Grimmspeed BRZ/FR-S Pulley Cover Bedienungsanleitung PDF herunterladen

GrimmSpeed Install Guide Series

Installing the GrimmSpeed BRZ/FR-S Pulley Cover

Updated 4/23/14

Introduction: This guide will illustrate the installation of the GrimmSpeed Pulley

Cover. The difficulty here is super low, so take your time and enjoy the job!

Tools: The tools listed below are suggested for this task (figure 1). Optional tools

are noted.

- 10mm socket and accompanying ratchet

- 5mm Allen Wrench

- Pliers (helps release clips)

Figure 1: Tools

Tips: Use care to not drop the anodized spacers into your engine bay, but if you do,

don’t burn yourself while you reach for them!

Procedure:

1. Begin by collecting your tools and popping your hood. This’ll be quick!

2. Now, remove your factory alternator and a/c compressor covers. This will

require a 10mm socket. Set the nuts and the cover aside, you will not be

needing them.

10mm

socket/ratchet

5mm Allen

1 2 3 4 5

GrimmSpeed Install Guide Series Installing the GrimmSpeed BRZ/FR-S Pulley Cover Updated 4/23/14 Introduction: This guide will illustrate the install

Figure 2: Remove 10mm bolts on oem alternator cover Figure 3: Remove a/c compressor cover 3. You’ll now need to release the two wiring harness c

Figure 4: Remove wiring harness clips from oem cover 4. Rock on! Now, we’ll install the GrimmSpeed harness mount as pictured. At this time, only re

Seite 4

5. Now prep the passenger side of the cover with the shorter bolt, shorter standoff and washer as shown. Then, get the bolt started threading into yo

6. Next, use the longer bolt and standoff to assemble the driver’s side with the a/c compressor as shown. Bolt  Small Washer  Cover  Lon

Keine Kommentare

Grimmspeed BRZ/FR-S Pulley Cover Bedienungsanleitung